Wolf 3D new map, 7/12/05 (slight tuning, changed trigger to falling edge)
07-12-05 | 01:49 PM
#1
Thread Starter
Rotary Enthusiast
iTrader: (1)
Joined: Feb 2001
Posts: 1,259
Likes: 4
From: long island
new map, 7/12/05 (slight tuning, changed trigger to falling edge)
http://countercultured.net/maps/r07-12-05.wmf
after noticing that my cas was wired in reverse of the trigger type that i was using, i changed it to falling edge. I had to advance my CAS to make up for the signal coming later.
I no longer get errors on start.
thanks to turborotor for starting a discussion on this and bringing it to light.
also, from dealer tech 2 on whether to use rising or falling edge.
after noticing that my cas was wired in reverse of the trigger type that i was using, i changed it to falling edge. I had to advance my CAS to make up for the signal coming later.
I no longer get errors on start.
thanks to turborotor for starting a discussion on this and bringing it to light.
also, from dealer tech 2 on whether to use rising or falling edge.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 04:30 PM
