Started tearing apart my project TII. The guy i bought it from was running 5 different aftermarket guages + his own computer management (dunno which) There was ALOT of new installed wires under teh dash when i pulled it out that were not connected to the dash harness. However There are 2 areas where teh dash harness has been hacked up, Now im trying to figure out what they went to, and if they are needed. Heres some pics.

This is to the right of the steering column. and a few pics zoomed in





This are was down by the fuse box on driver side, had this strange clip looked like it spliced into another green wire.



Sorry about the shitty camera but its all i got to work with

 

bump

 

look at the wire and post the colors so someone not lazy can look it up

 

the plug in the first picture looks like the circuit opening relay and the other with the tape around it goes nowhere.without the circuit opening relay your car wont start.

 

It looks like the driver side wiring is from an old Alarm system was hooked up. The other side"Passenger" looks to be from the old stereo system.. amp maybe.

 

alright so The left plug next to the floor, The color of the wire that was spliced IS green and red stripe.

The color of the "6 prong plug" near the steering column, the colors spliced are, Blue and red stripe and Black and white stripe.There are two black and white stripe wires on this plug this one is the middle one. Hoping that these arent important because he left no room re attach them.

The "four prong plug" next to the six prong only has two wires running to it and the metal connectors inside the plug are gone and no wires that seem to lead to it. I dont know if its supposed to be that way but looks to be.

Thanks for the help guys i sat and stared at wiring diagrams for hours tryin to figure this out, BUt electrical **** is not what im good at. I need "wiring for dummies" . Anyways thanks alot!

 

the 6 prong plug blue/red stripe goes to fuel pump,thin black/white is ignition power,thick black/white goes to the ECU,and i beleive there is a brown wire in there that goes to the engine harness for the airflow meter signal,black wire is ground.if im correct there is only 5 wires on that plug.look up circuit opening relay on the wiring diagrams.

 

Lol so pretty much in other words. Get a new harness or somehow fix it. Thanks rotarydave for the help

 

^or go to the local junkyard and get the circuit opening relay and the plug attached to it,just give it extra length and cut it off,then attach to yours.

 

Do s4 NA's and s4 TII's share the same plug? cuz its going to be hard to find a TII at a junkyard

 

yeah same plug.as a matter fact i have an extra plug with the relay on it you can have it just pay shipping.pm me