Sup guys I have been leaning on these rims since I have seen them on a mazda Cosmo/RX5/121 over on the japanesenostalgiccar.com forums. Located here.

http://japanesenostalgiccar.com/foru...14751&start=20

My question to all the old school rim guys here is. I want to keep my 4 lug hubs and stay in the 15" rim sizes along with a dececnt rim lip on the rim. So what offeset should I go with to attain a flush look and none of that Bazooka looks you know just a good wide lip appereance in the stock fenders? My suspension set up is the Tokico Blues with the red springs. They were installed by the original owner back in the late 90's to the early 2000's I'm not sure. I was considering the 15 x 7 with a offset of +35.

Can you guys please give some feed back on this setup along with personnel that have owned these rims Thanks.

Also I got the rim specs from this sheet on the Work Equip site.

http://www.workwheelsusa.com/media/w...1_SPEC09A4.pdf

Thanks Kelly

 

Kelly is that you man???? its been forever since i talked to ya.. glad to see you still an rx7..


id suggest going 15x8 and 9 +25 or +30 all around will fit fine with a roll.

 

Yep it's me Jaime........ is that you?????
Whats good man hows everything going with you? I joined back up in the Army back on late 09 and stationed @ Fort Carson Colorado Springs now. I sold two of my FC's for this cherry 86 RX7 I got from the original owner up in the high desert before I left back for the Army. Precaitte the advise with these rims man. Been looking at them for a while now.