RX7 Store GTX35
#26
The one
iTrader: (5)
so finally got around to finish this single turbo project... Jason from RX7store.net did redo my manifold and now i have 1 inch on each side... i do give them prob for always picking up my calls and taking care of the issue.
new issue that i have... the turbo drain can't sit straight down because it hit the turbo housing... as you can see in the picture the oil feed is about 50 degree... do you guys think that this is ok ? will it hurt the turbo?
thanks for your input...
new issue that i have... the turbo drain can't sit straight down because it hit the turbo housing... as you can see in the picture the oil feed is about 50 degree... do you guys think that this is ok ? will it hurt the turbo?
thanks for your input...
if you go here http://www.rx7store.net/category_s/425.htm
There are some pictures of how we have installed them.
Jason
Last edited by Jason; 05-18-12 at 08:57 PM.
#27
Full Member
Thread Starter
iTrader: (3)
Join Date: Apr 2009
Location: Houston
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
the drain flange doesn't fit straighter than the picture i posted...
seem like you install this turbo at 40 degree the same way i have...
http://www.rx7store.net/PhotoDetails...ctCode=Photo48
seem like you install this turbo at 40 degree the same way i have...
http://www.rx7store.net/PhotoDetails...ctCode=Photo48
From looking at your pics you have a lot of room to clock the turbo. Does the drain flange have an angle on it?
if you go here http://www.rx7store.net/category_s/425.htm
There are some pictures of how we have installed them.
Jason
if you go here http://www.rx7store.net/category_s/425.htm
There are some pictures of how we have installed them.
Jason
#28
Racing Mechanic
This is how i solve mine
It was a problem really hard to solve
But i ended up installing the turbo almost straigt
One Allen and the other 10mm
It is possible to install it properly
It was a problem really hard to solve
But i ended up installing the turbo almost straigt
One Allen and the other 10mm
It is possible to install it properly
Thread
Thread Starter
Forum
Replies
Last Post
Project88Turbo
3rd Generation Specific (1993-2002)
8
08-29-15 02:23 PM
thecody59
1st Generation Specific (1979-1985)
40
08-23-15 06:41 PM