rx7 fd single turbo setup question
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: Feb 2008
Location: Ontario
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
rx7 fd single turbo setup question
Hey guys, I'm thinking about running a single turbo t04s(non ball bearing) on my fd with greddy m spec intercooler, power fc, greddy profec b 2 boost controller without a street port or anything but just keeping it low boost what do you guys think? will it damage my car?
#2
Original Gangster/Rotary!
iTrader: (213)
Damaged as in, you're parked in the parking lot at the supermarket and a shopping cart smashes into your FD?
Not sure what you're asking.
Upgrade your fuel system, and get the car worked on and tuned by a rotary (and FD) specialist.
Not sure what you're asking.
Upgrade your fuel system, and get the car worked on and tuned by a rotary (and FD) specialist.
#4
Full Member
Thread Starter
iTrader: (2)
Join Date: Feb 2008
Location: Ontario
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
Yah i'll defenetly get a good tuner but the install of the single turbo and intercooler seems like any good mechanic can do. And i meant damaged as in ruin my engine, you know blow my apex seals, and the m spec intercooler not being effecient enough for the T04s. Since many people usually do street ports, or rebuilds on the engines before installing a single turbo i was just woundering would it be bad just installing it with intercooler, power fc, boost controller with the engine as is and keeping it at low boost?
#5
Street port just gives you more power, you don't necessarily need it. As for any mechanic doing the swap, its not that simple since you have to block off a lot of things and remove some. Single turbo won't make you pop a seal, a bad tune or mechanic will.
Where abouts in Ontario are yah, I do tuning
thewird
Where abouts in Ontario are yah, I do tuning
thewird
Trending Topics
#9
Eats, Sleeps, Dreams Rotary
iTrader: (52)
FD3s RX-7 Block Off Plates
Banzai Racing FD Block-Off Plates Location