50tooslow

In KC the cheapest place to buy Aeroquip fittings is Swan engineering. Unless you have a connection to get them at cost.

rxrotary2_7

lane_change:
here is a thread with some good info in it for you about AN fittings and SS lines. https://www.rx7club.com/forum/showth...hreadid=152726

LTProject

I had a chart on fuel pumps and there flow rates i since lost the chart but there was a pump on there that had good flow at 90psi that i remember. Its a 930 turbo rear pump external mount and the part # ends in 301. Made by bosch and i priced it in the aftermarket for 200. Ill keep lookin for that though, and if anyone knows of this pump, chime in.

teachermechanic

iTrader: (4)

Hi LANE CHANGE this E-mail:
ilmb@globetrotter.net
And i ship picture

3rdGen7

Hi Guys,

At the moment I ran a -6 line to use with my non-seq twins at 16 psi but when I am gonna' install the T51 R KAI, do you think I should use that -6 for the return and run two -10 lines with a Y to the primaries and secondaries then out of the rails into another Y into the reg and then out of the reg to the -6 for the return ??

Seeing that I already have the Cosmo pump ..what other pump should I get to work with it for the KAI ?? Another Cosmo pump or should I get something like a GTR N1 pump and use that one to feed the secondaries and leave the Cosmo on the primaries.. or should I just pull the Cosmo pump and run 2 GTR N1's or similar sized pump with the KAI ? .. I'm looking for 600-650 hp.

Any advice would greatly help.