What did you do to your FB today?
#6707
Any intrest in a build write up
Hey all I can't thank some of you enough. The forum has been great and the build threads that everyone posts are an amazing help. Ive been using the writeup's from wangracing and Viking War Hammer and just wanted to see if there was any interest in me doing one as well.
#6710
Damn, it did start!
any picture before you sprayed? what kind of rust issues if any did you have to contend with? What did you use for a coating? Also that is a great purple.
#6711
Full Member
iTrader: (1)
I spent the last few days pulling my rear axles and got new bearings put on today. Years of curbing had the passenger side grinding but slipping off a rhino ramp really gave it the clunks.
Maybe a dumb question, but I read a post saying to put bearing grease on the axle seals for assembly. Will coating with a bit of diff oil work fine?
Maybe a dumb question, but I read a post saying to put bearing grease on the axle seals for assembly. Will coating with a bit of diff oil work fine?
Last edited by klptk; 01-27-18 at 02:43 AM.
#6715
Helped unoack the SR20DET for the swap. It came with quite a few extra oarts that will be sold to offemset the cost of everything involved. Also, stripped the Ford 7.5 down for the brackets to be welded on
#6720
Old [Sch|F]ool
It's a single bolt pattern. I had Da Boss chuck up the Ford flange and machine the inner OD a little larger to accept the Mazda spigot diameter. I gave him a Kia Sportage front driveshaft chunk for reference The Mazda bolt holes are merely drilled in where there wasn't a Ford pattern in the way.
Having major difficulties getting the Watts to work with it.
Having major difficulties getting the Watts to work with it.
#6722
Senior Member
iTrader: (1)
Hey all I can't thank some of you enough. The forum has been great and the build threads that everyone posts are an amazing help. Ive been using the writeup's from wangracing and Viking War Hammer and just wanted to see if there was any interest in me doing one as well.
#6723
#6725
Senior Member