Hks twin power on fc3s questions.
#1
F**K THE SYSTEM!!
Thread Starter
Hks twin power on fc3s questions.
Need help trying to make a free hks twin power made for hks evo8 work for my leading coils.
I can't seem to find a good detailed write up for hks twinpower into an fc3s. All I know is that white wire from hks unit goes to black wire on leading coil.
Do they mean black wire on coil harness or black/yellow on "ignition harness".
I'm not sure if it intercepts leading black wire or if it's just attaches to it.
I can't seem to find a good detailed write up for hks twinpower into an fc3s. All I know is that white wire from hks unit goes to black wire on leading coil.
Do they mean black wire on coil harness or black/yellow on "ignition harness".
I'm not sure if it intercepts leading black wire or if it's just attaches to it.
#2
Senior Member
I've got an HKS Twin Power Rotary hooked up to mine. I can take some pictures and show you how it's hooked up if you'd like. The HKS diagram is in black and white, and is hard to make out so it took me quite a while to figure it out.
#3
Senior Member
Where to connect HKS Twin Power
I'm not sure what wires you have to work with, but here is how the wiring works for the version I have.
5 wires
Black - Ground
White - Leading Coil
Yellow x 2 - Trailing Coil
Red - Trailing Coil, trigger
Black Wire
Black wire grounded to battery
White wire to leading coil
Finger pointing to connection point
Yellow wires to trailing coil
connection points on bottom of trailing coils
Red trigger wire to trailing coil
Upper left coil terminal post for red trigger wire
These should be the only connection points you need. Please don't cut into your wire harness to splice them. Take the hks harness and solder and heatshrink some nice loops on it and all you have to do is use the nuts on the coils to bolt it down. Good luck
5 wires
Black - Ground
White - Leading Coil
Yellow x 2 - Trailing Coil
Red - Trailing Coil, trigger
Black Wire
Black wire grounded to battery
White wire to leading coil
Finger pointing to connection point
Yellow wires to trailing coil
connection points on bottom of trailing coils
Red trigger wire to trailing coil
Upper left coil terminal post for red trigger wire
These should be the only connection points you need. Please don't cut into your wire harness to splice them. Take the hks harness and solder and heatshrink some nice loops on it and all you have to do is use the nuts on the coils to bolt it down. Good luck
#4
Need help trying to make a free hks twin power made for hks evo8 work for my leading coils.
I can't seem to find a good detailed write up for hks twinpower into an fc3s. All I know is that white wire from hks unit goes to black wire on leading coil.
Do they mean black wire on coil harness or black/yellow on "ignition harness".
I'm not sure if it intercepts leading black wire or if it's just attaches to it.
I can't seem to find a good detailed write up for hks twinpower into an fc3s. All I know is that white wire from hks unit goes to black wire on leading coil.
Do they mean black wire on coil harness or black/yellow on "ignition harness".
I'm not sure if it intercepts leading black wire or if it's just attaches to it.
Thread
Thread Starter
Forum
Replies
Last Post
ComradeDerek
2nd Generation Specific (1986-1992)
3
04-09-17 09:29 PM
theonlygreat
2nd Generation Specific (1986-1992)
9
04-14-03 06:04 AM