Another Jason Another Basic FD Build
#76
Troubleshooting
RX7 Solenoid PRE/WG Duty
The solenoid is right behind the vacuum chamber tank. Make sure the connector with the white dot is connected to the solenoid with the white dot, if the dot is missing, connect the connector with the white dot to the solenoid that is on the driverside (LHD). I hope this help, let me know how it goes.
-Jason
#80
Hey Jason killer build! I actually just bought a bw s362, and was doing a very similar build (how I stumbled upon this thread). Was wondering if it was possible for you to email me or PM me. Going to follow this thread and sort of follow in your footsteps if that's alright. I'd like to get your contact info in case this thread ever gets lost lol! Let me know. Greatly appreciated. Keep up the good work!
#81
3/11 another minor update
*362sxe project put on hold until end of this year
-heat shielding and barrier for the ic piping and the smic
-weather stripping to seal off the smic duct
*362sxe project put on hold until end of this year
-heat shielding and barrier for the ic piping and the smic
-weather stripping to seal off the smic duct
-denso race plugs (yay for no more ignition break up under boost, hope they last longer than the NGk platinum plugs
-replace the hks mushroom foam filter with k&n filters
-replace the torn exhaust ground
-replace some of the ic coupler with expandable hump
-replace some of the worm clamps to all t-bolt for the ic piping
-did an oil change with idemitsu 10w30 oil
-finally bought a premix kit, so i can stop being lazy on pre-mixing.
No more excuse! Lol .__.
-replace the hks mushroom foam filter with k&n filters
-replace the torn exhaust ground
-replace some of the ic coupler with expandable hump
-replace some of the worm clamps to all t-bolt for the ic piping
-did an oil change with idemitsu 10w30 oil
-finally bought a premix kit, so i can stop being lazy on pre-mixing.
No more excuse! Lol .__.
Last edited by Brody8877; 03-12-17 at 05:48 AM.
#87
Put it in the microwave!
iTrader: (22)
Some updates:
retuned by Daniel of garage life
video below
https://www.instagram.com/p/BR4YW-0hyvQ/
Results: 280rwhp 260rwtq sae corrected.
retuned by Daniel of garage life
video below
https://www.instagram.com/p/BR4YW-0hyvQ/
Results: 280rwhp 260rwtq sae corrected.
#94
Update: A bit of bad news, I accidentally beached my FD on my driveway again and ever since then I had very noticeable exhaust leak and smoke coming from the engine bay area. I was hoping I have damaged my downpipe, but after replacing my downpipe, I still have same noticeable exhaust leak and smoke. I was able to isolate the location of the smoke and it was coming from turbine housing on the primary side. It seems like the twins are officially done. Hindsight is always 20/20, I should have focus on the single turbo conversion instead of rushing to get my car somewhat track ready with the twins.
Back on track with the S362sxe project.
Back on track with the S362sxe project.