Savannah RX-7 Club
#3502
#3503
Nice vid hadnt seen that before.
#3504
They do have black ones..Id send him a message over Ebay and he will most likely do one custom for ya! I should be getting it in soon and Ill take some pics and let you know how it is.
Edit- I seen in your album you had a 99 spec bumper on your Rx7..do you still happen to have that bumper?
#3505
#3509
#3510
Did some work on Moes 7 today.
What we accomplished.
-Front Rebar on
-Dual oil coolers installed
-Installed hood
-Installed fenders
-tucked some interior wires
-tighted a shot ton of bolts that were loose
-set steering wheel to correct place
-cleaned up interior a bit but need a shop vac (get on that **** moe )
pretty sure his turbos are blown......cars smoking like a chevy, engine sounds strong though.
What we accomplished.
-Front Rebar on
-Dual oil coolers installed
-Installed hood
-Installed fenders
-tucked some interior wires
-tighted a shot ton of bolts that were loose
-set steering wheel to correct place
-cleaned up interior a bit but need a shop vac (get on that **** moe )
pretty sure his turbos are blown......cars smoking like a chevy, engine sounds strong though.
#3512
Yeah we did alot more just didnt put it. Lets work on getting your radiator out and repairing it. That wont take but a hour and a car drive.
#3520
You need to verify that its running on 1 rotor, im sure someone around here has a makeshift compression tester you could borrow..
It could just be somethings wrong with the motor/turbos, you NEED to start by doing a compression test to see if you have low compression on a rotor and then troubleshoot/rebuild from there. It could be a couple vacuum lines that are disconnected.
Ill head over this weekend and take a look at it for ya. Just dont **** the neighbors off to bad with your revving.
It could just be somethings wrong with the motor/turbos, you NEED to start by doing a compression test to see if you have low compression on a rotor and then troubleshoot/rebuild from there. It could be a couple vacuum lines that are disconnected.
Ill head over this weekend and take a look at it for ya. Just dont **** the neighbors off to bad with your revving.
#3521
Lol. Mark has a compression tester for a piston engine but he said you should just be able to hear while you crank with spark plugs out and fuel pump relay out. Should be a kind of hiss I believe he said if I remember right.