Haha FC3S_nataku, when are we going to get together? You should help me with my exhaust manifold gasket

...so what side of town is everyone on? if we were to have a meet and eat where would be best have it.

I'm in Ponte Vedra Beach but I don't mind driving a little ways.

Arlington... so I vote...... ARLINGTON. :)

I vote for my place... St. Marys GA. Drive bitches.

hows the engine coming along?

Just waiting on parts. If anyone has carbide burrs and a streetport template I'll port it for him. Otherwise, it's just sitting in a bunch of boxes right now awaiting goodies :)

I was wondering if there is a port setup that would yield more power but not hurt the mpg as much.

Of those two, you can pick one. I think the best compromise is a stock ported high compression 4-port turbo. You get the fuel efficiency of an NA, since the higher compression ratio yields more complete combustion when cruising and light scooting around town. The only compromise is that you have to soak it down with fuel and retard timing under boost, but you'll spool the turbo faster and make more power while you're at it.

Im on the westside

Mazwar...never seen you here. What kind of car do you have? Mods?

Welcome to the wonderful world of OZ!

I was told just porting the exhaust would be ok

don't know where else to post this but if you need some FD body panels...

Mazda Rx7 1993 Parts car, front clip or rear clip available

Not mine but came across it

I certainly dont mind driving to a meet
I'm in east arlington

I think somewhere by the airport is a good compromise between GA, and the folks at the beach.

I know. I've been slacking on the forums. I have an 89 gtu. So far exhaust

Im in arlington but.dont mind driving. North jax, near airport, sounds about right.

Cool cool, mazwar.

I was very productive today. My Cosmo fuel rail came in on Saturday so just installed it and a few other things. Looks good.

Sent from my RX7 using RX7Club

Anyone up for a meet this coming Saturday morning? Up by the airport?

Sure, where are you thinking?

Cracker Barrel? Theres a Panera too... but in any case that shopping center should be good.

Why not Dames Point park or Hugenot/Little Talbot island, or Ft Clinch in Fernandina
lot nicer spots.....

nice. i kinda miss my rotary days sometimes.

What is the best way to clean housings? So i could avoid the 25 dollar fee from goopy

Super Clean... the stuff in the purple bottle. Shit is LEGIT!

I would like to go to a meet for sure. I'll be leaving Sunday for two months for work and it's a long time since I've been out.