who much was the new set up from act, good luck out there time to hit 5's

 

I went to the track and working my 60' down. Still slow but down to 1.66 but real good relative to the 1.9's I have been pulling. I did that off my 2 step. Still have lots of spinning. Don't know if I want to go up or down on luanch rpm's. I won't have my tranny back for sure. G/L with the clutch.

 

I am personally running a Sachs 765 pressure plate drilled to the stock flywheel with a 4 puck Sachs sinter plate. Im using the OS giken pull to push converter and modified it and don't have any problems with slipping clutch anymore. it was hard work thou to get it working.

 

Heck, I will be happy to just get back to 6.4's again. Sintered disk from act is custom and runs 418. Then just add a extreme plate. Heading to import show down at 5 am in the morning. Will add a thread with results. I don't expect to break into the nine's since the temp will be 96 degree's! Bet
Track temp will be 140's and greasy! Humidity will be in the 60's. Going to be nasty hot.