12,7mm studs, drilling
01-31-06 | 06:18 AM
#1
Thread Starter
Junior Member
Joined: Dec 2004
Posts: 5
Likes: 0
From: Trondheim, Norway
12,7mm studs, drilling
I am about to drill bigger holes for 1/2" studs in a 13b engine.
Does anybody know the 'dimensions' of the end plates and rotor housings, that is the distances from hole to hole and their configuration? (X-Y coordinates will be fine =)
The drilling will be done by CNC, it will be a lot easier and more exact if I have the measurements as it came from the factory, instead of me trying to measure the distances from hole to hole, f***ing up along the way.
Have been through all the standard faq's and sticky's, to no avail, strange because this isn't rocket science, I guess anybody with +600 hp has done this mod?
Does anybody know the 'dimensions' of the end plates and rotor housings, that is the distances from hole to hole and their configuration? (X-Y coordinates will be fine =)
The drilling will be done by CNC, it will be a lot easier and more exact if I have the measurements as it came from the factory, instead of me trying to measure the distances from hole to hole, f***ing up along the way.
Have been through all the standard faq's and sticky's, to no avail, strange because this isn't rocket science, I guess anybody with +600 hp has done this mod?
