Power FC Under sensor check... What is wrong if it show fuel?
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Mn
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Under sensor check... What is wrong if it show fuel?
I just installed a supra tt fuel pump but have started the car yet. I checked the senors in my pfc and "fuel" is highlighted. It is showing 4.99 volts. Is this normal when changing a fuel pump or is something wrong?
Thanks
Jeremy
Thanks
Jeremy
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,909
Likes: 0
Received 123 Likes
on
72 Posts
The manual (did you read it) states on page 35:
[FUEL] ... Fuel Temp Sensor
Thus if yours is reading full voltage as it is, then either your sensor:
(1) has been pulled for an upgrade to a new secondary rail which the sensor can not be used with like in using the Bosch 1600s
(2) you have a bad sensor
(3) your sensor wiring has an opening in it
[FUEL] ... Fuel Temp Sensor
Thus if yours is reading full voltage as it is, then either your sensor:
(1) has been pulled for an upgrade to a new secondary rail which the sensor can not be used with like in using the Bosch 1600s
(2) you have a bad sensor
(3) your sensor wiring has an opening in it
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
LunchboxSA22
2nd Generation Specific (1986-1992)
37
10-26-15 10:53 AM
befarrer
Microtech
3
08-22-15 05:52 PM