Power FC Speed Reading on Commander
#1
Got Rotors?
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Des Moines, Iowa
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
Speed Reading on Commander
I've yet to figure out why my speed displays wrong. When i switch it to graph mode, the speed somewhat follows rpm motion and is completely off. Anyone else have this problem because i couldn't find anything with the search function.
#4
Got Rotors?
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Des Moines, Iowa
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
I know it's in kilometers. And the rest of the readouts are correct.
The thing that's weird is that it doesn't have a constant curve when i'm accelerating. Like when i get on the highway. You think it'd be a somewhat constant curve but mine drops a little when i shift and then starts jumping around. Usually when i'm at maybe 5mph, it reads 20+ kph. When i'm foing 40mph, it says i'm going 90-120kph. And when i'm going 70mph, it reads as if i'm going 120-180kph.
The thing that's weird is that it doesn't have a constant curve when i'm accelerating. Like when i get on the highway. You think it'd be a somewhat constant curve but mine drops a little when i shift and then starts jumping around. Usually when i'm at maybe 5mph, it reads 20+ kph. When i'm foing 40mph, it says i'm going 90-120kph. And when i'm going 70mph, it reads as if i'm going 120-180kph.
#5
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,909
Likes: 0
Received 123 Likes
on
72 Posts
You have ways to figure this out.
(1) swap DL with someone
(2) if it still is off, then the DL is OK
(3) swap PFC with someone
(4) if it still is off, it is either wiring or the speed sensor.
(1) swap DL with someone
(2) if it still is off, then the DL is OK
(3) swap PFC with someone
(4) if it still is off, it is either wiring or the speed sensor.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM