u lose

--------------------------------------------------------------------------------

hey guys....yes i have searched the forum.... but i need a correct order and direction..... i have the power fc and commander uninstalled. it is used. it was on a 500 hp rx7 and i was told it was reset for stock maps...

my mods that are installed right now are, apexi gt spec exhaust, apexi bov, intake kit, boost and water temp gauges...uninstalled are the power fc, koyo rad., rx7 store mid and downpipes...
1... how do i install? i think i can find a thread or 2 on this...there are no pins that are cut on this unit so what do i need to do.
2..how do i tune it? do i need def. need wb02 and datalog? will the aem 6 in 1 wide band be a good choice to monitor a/f? it says i don't need a laptop to monitor it.... so my question is this... what exactly do i need the datalog it for ? if i can program my power fc with the commander, and watch the air fuel, then that should be sufficant..

i've done hours of searching with many diffenent threads on this subject but not in a direct order...
i just need to get started in the right direction. thanks guys

TailHappy

Start with the sticky at the top of this forum. That's the best tutorial I've found to date.