Power FC Is my PFC dead?
#1
Full Member
Thread Starter
iTrader: (6)
Join Date: Mar 2007
Location: oregon
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Is my PFC dead?
My car died at a local autocross last weekend and i can't figure out what's wrong. It will turn over but die immediately. I've checked the sensor read out on the PFC and they are way out of whack.
PIM 0.03
VTA1 0.01
VTA2 0.01
VMOP 0.00
I installed the stock ECU and it fires right up and idle ok. I've removed the airpump so it's not perfect but ok.
I tried replacing the TPS in hopes that it would make some difference but it doesn't. I've also tried disconnecting the map and tps to see if the reading change and they do read that they are disconnected.
Any ideas?
PIM 0.03
VTA1 0.01
VTA2 0.01
VMOP 0.00
I installed the stock ECU and it fires right up and idle ok. I've removed the airpump so it's not perfect but ok.
I tried replacing the TPS in hopes that it would make some difference but it doesn't. I've also tried disconnecting the map and tps to see if the reading change and they do read that they are disconnected.
Any ideas?
Trending Topics
#12
REPU Garage
iTrader: (17)
Join Date: Jun 2007
Location: Northern Colorado
Posts: 623
Likes: 0
Received 0 Likes
on
0 Posts
I had the same issue with a PFC I had once. I had an electrical engineering friend look at and he said all those sensors share a common ground within the PFC and when it goes bad, it will not read voltage from those sensors (obviously).
#14
REPU Garage
iTrader: (17)
Join Date: Jun 2007
Location: Northern Colorado
Posts: 623
Likes: 0
Received 0 Likes
on
0 Posts
Yes, I replaced the PFC with a brand-new unit and no problems, been running fine ever sense.
General rule of thumb is; if the car won't start on the PFC, but will run fine on the stock ECU, then you have a bad PFC. This, of course, isn't taking into consideration a tune so horrid it would prevent your car from starting, but I highly doubt this is your case.
I will call him and see if he remembers how to fix it, it said it wouldn't be too bad if I recall.
General rule of thumb is; if the car won't start on the PFC, but will run fine on the stock ECU, then you have a bad PFC. This, of course, isn't taking into consideration a tune so horrid it would prevent your car from starting, but I highly doubt this is your case.
I will call him and see if he remembers how to fix it, it said it wouldn't be too bad if I recall.
#15
REPU Garage
iTrader: (17)
Join Date: Jun 2007
Location: Northern Colorado
Posts: 623
Likes: 0
Received 0 Likes
on
0 Posts
Just called my engineer friend...
He said most likely it's a bad 5v regulator internal to the PFC. Should have part #7805 (generic part #) or circuit IC18 on the PFC main board, usually a 3-pronge chip on the board (with a tab on the back to bolt to the board/chassis).
If you can de-solder the chip and remove it, solder it back in, it should only cost you $2 for the part.
He said most likely it's a bad 5v regulator internal to the PFC. Should have part #7805 (generic part #) or circuit IC18 on the PFC main board, usually a 3-pronge chip on the board (with a tab on the back to bolt to the board/chassis).
If you can de-solder the chip and remove it, solder it back in, it should only cost you $2 for the part.
#16
Full Member
Thread Starter
iTrader: (6)
Join Date: Mar 2007
Location: oregon
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info. I think I might get another PFC and send mine in to Apexi to get fixed then sell one of them. I can't be without my car for 3 months and i don't trust my soldering enough to do it myself.
#17
Full Member
Thread Starter
iTrader: (6)
Join Date: Mar 2007
Location: oregon
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Progress update: Got a new (used) PFC. Installed it. Car ran great. Today coming home from work it dies again. Same thing. Same from the sensors. I put in the stock one again and it started right up.
Does this mean I have a short? I take it I need to track down the short and get another PFC? How do you go about tracking down a short?
Does this mean I have a short? I take it I need to track down the short and get another PFC? How do you go about tracking down a short?
#18
Rx-hippie
iTrader: (1)
Join Date: Sep 2003
Location: Torrance CA
Posts: 2,076
Likes: 0
Received 0 Likes
on
0 Posts
Have you checked your Alternator output?
With the stock ECU, fire up the car and measure the output of the alternator to ground while revving to 3krpms. The output voltage should be ~12.6-13.8V. If you are seeing anything higher than 14V then the alternator most likely killed the PFC. I have seen a bad alternator feed up to 18V which killed the battery and knocked out a PFC.
Worth a shot taking a look. I am not to sure it would be a short, considering it runs with the stock ECU.
Have you already sent the first PFC to apexi? They may be able to help you determine the root cause of failure.
Good luck
With the stock ECU, fire up the car and measure the output of the alternator to ground while revving to 3krpms. The output voltage should be ~12.6-13.8V. If you are seeing anything higher than 14V then the alternator most likely killed the PFC. I have seen a bad alternator feed up to 18V which killed the battery and knocked out a PFC.
Worth a shot taking a look. I am not to sure it would be a short, considering it runs with the stock ECU.
Have you already sent the first PFC to apexi? They may be able to help you determine the root cause of failure.
Good luck
#19
Full Member
Thread Starter
iTrader: (6)
Join Date: Mar 2007
Location: oregon
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Have you checked your Alternator output?
With the stock ECU, fire up the car and measure the output of the alternator to ground while revving to 3krpms. The output voltage should be ~12.6-13.8V. If you are seeing anything higher than 14V then the alternator most likely killed the PFC. I have seen a bad alternator feed up to 18V which killed the battery and knocked out a PFC.
Worth a shot taking a look. I am not to sure it would be a short, considering it runs with the stock ECU.
Have you already sent the first PFC to apexi? They may be able to help you determine the root cause of failure.
Good luck
With the stock ECU, fire up the car and measure the output of the alternator to ground while revving to 3krpms. The output voltage should be ~12.6-13.8V. If you are seeing anything higher than 14V then the alternator most likely killed the PFC. I have seen a bad alternator feed up to 18V which killed the battery and knocked out a PFC.
Worth a shot taking a look. I am not to sure it would be a short, considering it runs with the stock ECU.
Have you already sent the first PFC to apexi? They may be able to help you determine the root cause of failure.
Good luck
I'll check that tomorrow.
I've haven't sent in my PFC yet. It's good I waited. Now I can save on shipping by sending two at once.