Power FC initialized pfc now runs like garbage
#1
Senior Member
Thread Starter
Join Date: Aug 2008
Location: campbell river british columbia
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
initialized pfc now runs like garbage
hi, so i had my car running fine with a idle of 13.8 and it was sometimes a bit jumpy so i figured a pfc reset would fix the idle. i reset it and loaded the same map and now it just runs like absolute garbage, on my evc it says its only pulling -3.4 and sounds like its gurgling and wont rev freely. before i reset the pfc it reved freely... i dunno what went wrong?..
#2
Registered User
iTrader: (4)
Join Date: Nov 2010
Location: New Jersey
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
13.8 is a very tricky idle to achieve especially with 850 primaries (listed in your sig). You shouldn't have touched it.
Are you sure the map you uploaded was the same and uploaded successfully?
Btw, this should be in the pfc forum.
Are you sure the map you uploaded was the same and uploaded successfully?
Btw, this should be in the pfc forum.
#4
Senior Member
Thread Starter
Join Date: Aug 2008
Location: campbell river british columbia
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
thanks.. your right it should be back in the powerfc section. my bad.. anyone want to check the map email me at zxrazorxz66@hotmail.com and i will send it to you.. it sounds like its missing hard.. wont rev wont even idle and its really rich. i checked for spark and i have fuel and i have compression.. after i was getting frustrated and i uploaded a map that was previously working before my motor blew up and it seemed a little better but it still was missing bad.. i dunno whats going on.. really hard to get a video of it too.. it runs as if you just unflooded it and put oil in the combustion chambers. thats how it runs all the time now. can you say frustrating?
#5
Senior Member
Thread Starter
Join Date: Aug 2008
Location: campbell river british columbia
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
so i cleaned the plugs earlier with some sand paper and carb clean and let them dry out and put them back in and after about 30 minutes of idling they were wet and black. i think somethings wrong with the spark. plugs were brand new when i put the motor in.. seen 10 kilometers
Trending Topics
#9
Senior Member
Thread Starter
Join Date: Aug 2008
Location: campbell river british columbia
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
i know how easy it is.. but thats the thing it runs rough with any map.. ive tried my current map some older maps i had that i was driving the car with.. just nothing is working
#15
Senior Member
Thread Starter
Join Date: Aug 2008
Location: campbell river british columbia
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
lol.. yea its fixed sorry for not updating im in the works of moving just been busy. but yea was just cause i wasnt hitting write all because my fc edit window was smaller then usual so i couldnt see those buttons.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
08-13-15 04:55 AM