Power FC Idle Rpm
#1
Fanno
Thread Starter
Join Date: Jul 2004
Location: Pittsburgh
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
Idle Rpm
I just got a single turbo installed, and now my rpms are dipping down at idle. Is there a way to raise the idle RPM a bit on my power FC? If so can ya break it down for me?
Thanks
Thanks
#2
Hooray For Boobies!!!
http://www.scuderiaciriani.com/rx7/power_FC_manual.pdf
Read that.
But it will be under the settings tab, then the Rev/Idle tab, then you'll be changing the values in the last (lower) three settings. Those are for the idle with no load, idle with electrical load and idle with the A/C on.
Read that.
But it will be under the settings tab, then the Rev/Idle tab, then you'll be changing the values in the last (lower) three settings. Those are for the idle with no load, idle with electrical load and idle with the A/C on.
#4
Hooray For Boobies!!!
Did you disconnect the battery recently?
Becasue the PFC goes through a pretty indepth idle learn process every time you disconnect the battery. It needs to idle in all three stages (no load, electrical load, and A/C on) for ten minutes or so before it starts to come around and idle solid.
Read this also
http://www.apexi-usa.com/pdf/product...tation/197.pdf
Becasue the PFC goes through a pretty indepth idle learn process every time you disconnect the battery. It needs to idle in all three stages (no load, electrical load, and A/C on) for ten minutes or so before it starts to come around and idle solid.
Read this also
http://www.apexi-usa.com/pdf/product...tation/197.pdf
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM