Power FC Greddy 3-bar pressure sensor?
05-05-06 | 11:31 AM
#1
Thread Starter
RX-7 Bad Ass
iTrader: (55)
Joined: Jan 2002
Posts: 15,423
Likes: 2,477
From: Pensacola, FL
Greddy 3-bar pressure sensor?
Just a thought....
http://www.mohdparts.com/emanage/pre...sor/index.html
Greddy sells their 3-bar pressure sensor separately - you can also buy the harness for it and everything. Might be a good PFC upgrade to replace the stock MAP sensor.
The real neat part of it is the 60mm Greddy peak/hold/warning boost gauge uses the same sensor. So, if you were running that gauge, you could simply tap into the output signal from the gauge to use as your MAP signal. The above webpage has the voltage-to-pressure scale for the sensor.
BTW, the sensor is $99. It's a nice, quality, compact sensor too.
Dale
http://www.mohdparts.com/emanage/pre...sor/index.html
Greddy sells their 3-bar pressure sensor separately - you can also buy the harness for it and everything. Might be a good PFC upgrade to replace the stock MAP sensor.
The real neat part of it is the 60mm Greddy peak/hold/warning boost gauge uses the same sensor. So, if you were running that gauge, you could simply tap into the output signal from the gauge to use as your MAP signal. The above webpage has the voltage-to-pressure scale for the sensor.
BTW, the sensor is $99. It's a nice, quality, compact sensor too.
Dale
05-05-06 | 07:48 PM
#2
Originally Posted by DaleClark
Just a thought....
http://www.mohdparts.com/emanage/pre...sor/index.html
Greddy sells their 3-bar pressure sensor separately - you can also buy the harness for it and everything. Might be a good PFC upgrade to replace the stock MAP sensor.
The real neat part of it is the 60mm Greddy peak/hold/warning boost gauge uses the same sensor. So, if you were running that gauge, you could simply tap into the output signal from the gauge to use as your MAP signal. The above webpage has the voltage-to-pressure scale for the sensor.
BTW, the sensor is $99. It's a nice, quality, compact sensor too.
Dale
http://www.mohdparts.com/emanage/pre...sor/index.html
Greddy sells their 3-bar pressure sensor separately - you can also buy the harness for it and everything. Might be a good PFC upgrade to replace the stock MAP sensor.
The real neat part of it is the 60mm Greddy peak/hold/warning boost gauge uses the same sensor. So, if you were running that gauge, you could simply tap into the output signal from the gauge to use as your MAP signal. The above webpage has the voltage-to-pressure scale for the sensor.
BTW, the sensor is $99. It's a nice, quality, compact sensor too.
Dale
Nice! I wish I would have known this I have the GReddy boost guage... I ended up buying the Apexi map sensor for my power fc
Thread
Thread Starter
Forum
Replies
Last Post
troym55
3rd Generation Specific (1993-2002)
23
05-25-16 01:42 PM
