Power FC Chuck Westbrook Map
#1
Chuck Westbrook Map
In my folder on my computer I seem to have archived a downloaded PCF map from Chuck.
The map looks pretty good, and I am looking at some of the changes (not doing anything yet, and won't until I'm on a dyno w/ wideband).
But I noticed that his maps aren't up with the rest of the maps here, and I don't see any info on what mods chuck had on his car at time. Does anyone (maybe Chuck? :-) know, or have more information?
thanks,
-Erik
The map looks pretty good, and I am looking at some of the changes (not doing anything yet, and won't until I'm on a dyno w/ wideband).
But I noticed that his maps aren't up with the rest of the maps here, and I don't see any info on what mods chuck had on his car at time. Does anyone (maybe Chuck? :-) know, or have more information?
thanks,
-Erik
#2
and my maps
Since I just entered my maps today, here they are.
PFC purchased from Shane Racing. Then tuned by KDR on install. Then after a new motor (0-rings at 78K, prolly more to do with a higher pressure radiator cap than the PFC..) tuned again a little, by KDR.
Relevant mods are:
Stock Engine, and fuel (but new engine and cleaned injectors)
9's for all 4 plugs.
'99 turbos
efini y-pipe
Tripoint high flow cats (two)
RB catback
PFS IC and intake (intake has m2 style duct on bottom, though)
I'm as happy as can be without a good solid wideband session, now that the engine is broken in, but I believe it is rich, and I have the knock sensor going off on turbo transition, that I want to also tune out (see other thread).
In the attached spreadsheet, the red shows cells that differ from pfcchuck02.xls
PFC purchased from Shane Racing. Then tuned by KDR on install. Then after a new motor (0-rings at 78K, prolly more to do with a higher pressure radiator cap than the PFC..) tuned again a little, by KDR.
Relevant mods are:
Stock Engine, and fuel (but new engine and cleaned injectors)
9's for all 4 plugs.
'99 turbos
efini y-pipe
Tripoint high flow cats (two)
RB catback
PFS IC and intake (intake has m2 style duct on bottom, though)
I'm as happy as can be without a good solid wideband session, now that the engine is broken in, but I believe it is rich, and I have the knock sensor going off on turbo transition, that I want to also tune out (see other thread).
In the attached spreadsheet, the red shows cells that differ from pfcchuck02.xls
#3
IGL says it is yours. IGT says its mine.
Send me my old maps to cewrx7r1@yahoo.com and I will tell you what it is.
Send me my old maps to cewrx7r1@yahoo.com and I will tell you what it is.
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 10:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 11:57 PM