Ranger Yi

right now the power FC is between 12 and 13 psi. can someone help me change the power FC setting to a 10-8-10 boost pattern. is anyone in the houston area that can look at my car?

turbodrx7

iTrader: (43)

I dont think you can just "change" it..you have to have it tuned for that psi, i guess you could turn your boost controller down and then youll just run rich as ****. since i think it will dump enough for for 12 psi instead of you only running 10 psi. Good luck

cewrx7r1

iTrader: (2)

Wrong Wrong!

You can change the built in boost controller for different boost levels like reducing it from 12psi to 10 psi. When you run different boost levels (10 vs 12) the PFC like the stock ECU runs diffferent parts of the same map and the AFR should be OK depending on how well it was tuned. It will not go **** rich by doing this unless the fuel map is ****!

rynberg

Reread the manual regarding boost settings. You will have to adjust the boost duty cycles to lower the boost. Adjust your target boost levels to what you want to run.

Ranger Yi

i dont have the Power FC manual.. i gotta get it still.

reza

Maybe he does not have the FC Commander.

snarp

kahn

rynberg

You would think you would do that BEFORE posting a question on a simple procedure....or BEFORE installing the PFC, for that matter.

http://www.apexi-usa.com/support_installation.asp

Ranger Yi

i do have the commander too