Power FC boost question on PFC?
#1
boost question on PFC?
ok so i have noticed this lately (try to explain the best way i can) on the Commander screen in maps were is shows absolute boost pressure it only shows like +0.14 for like 8 Psi on my boost gauge and boost controller, or it will show like +.25 when i hit 14.7psi on my gauge... so shouldn't it be showing +1.00 if i am doing a bar of boost? anyone know what could be going on? any help would be great!
Thanks
P.S. sorry if this is confusing.
Thanks
P.S. sorry if this is confusing.
#3
Originally Posted by FD3RotorTurbo
i ment monitor not maps.
Maybe you should also view PIM voltage on the sensor screen to see if it is OK when on boost. Read attachment.
#4
Originally Posted by cewrx7r1
Frankly I never look at boost on the commander monitor screen. But I do look at boost on the datalogit logs when tuning. Since they read ballpark on the logs, they should also on the commander, I would presume.
Maybe you should also view PIM voltage on the sensor screen to see if it is OK when on boost. Read attachment.
Maybe you should also view PIM voltage on the sensor screen to see if it is OK when on boost. Read attachment.
#5
Hey Chuck quick question, if I install a MBC, do I just leave the boost control on the Commander alone? Please don't consider me thread jacking. I kinda have this problem too. I just got a quick question .
Jeremy
Jeremy
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM