Power FC AP engineering FC3s Power FC
#1
Full Member
Thread Starter
AP engineering FC3s Power FC
looking for installation instructons or someon who has this done to their car
ok i running a S5 T2
so i receenlt got an ap engineering Power Fc, and wheni install it i get the car start it hits 3000 and it dies i just have to find out if there is any other wiring mods i need to do to make this successful.
When i plug the old ecu in the car it runns till it floods out i upgraded to 800cc that is what the kit came with, there was no instruction on how to install power fc or FD air intake or Map sensor, so i followed instruction from FD power fc install from Banzai racing but i did not do the ignition coil mod since my power fc is for a FC3s
so can anyone help me out, am i supposed to leave the AFM in or mod it is connection
the car mods
brand new engine harness
R- Magic Turbo kit, included 800cc injectors all around, ap power FC , map sensor and IAT sensor.
ok i running a S5 T2
so i receenlt got an ap engineering Power Fc, and wheni install it i get the car start it hits 3000 and it dies i just have to find out if there is any other wiring mods i need to do to make this successful.
When i plug the old ecu in the car it runns till it floods out i upgraded to 800cc that is what the kit came with, there was no instruction on how to install power fc or FD air intake or Map sensor, so i followed instruction from FD power fc install from Banzai racing but i did not do the ignition coil mod since my power fc is for a FC3s
so can anyone help me out, am i supposed to leave the AFM in or mod it is connection
the car mods
brand new engine harness
R- Magic Turbo kit, included 800cc injectors all around, ap power FC , map sensor and IAT sensor.
#5
*reallly knowing the fc
Join Date: May 2007
Location: victory lane
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
No. remove the afm. itis a restriction. thats one of the best things about power fc -afm. i just got mine running with the power of the power fc. Whats really needed is a pin diagram of the power fc. that way i could get the check engine light to work with the power fc "over heat exhaust" warning light function.
#6
I R SAD PANDA W/O BAW
you dont need anything plugged into the AFM. all you need is an OEM FD map sensor or Apexi sensor (both 3 wires and adapt) and make your own adapter harnesses to the stock harness to which the stock TII pressure sensor plugs in. OEM FD AIT sensor bolted into my greddy elbow fine. This sensor is 2 wire and non polarized meaning it doesnt matter which way you plug it into the stock harness.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM
Turblown
Vendor Classifieds
0
08-18-15 10:01 PM