WTF??? ok, so Initialize All Data (All Data Init) returns everything to the factory default settings? So lets say that the FC was pre-programmed by SR, is that considered the “new” factory setting, in that, if I change things to someone else’s maps and decide I want to go back to the “pre-programmed” maps from SR, all I have to do is select “yes” under All Data Init. on the commander?

any one try this? any help would be appreciated.

Or are there IO, BIOS, CMOS type of default settings that are here and would go back to the Japanese original maps?


Thanks guys

 

If you initialize all data(reset) it will go back to the base maps. you will lose all programming that was done to it, which includes SR map programming that it came with.

 

damn!

thanks

so the best thing to do would be to write down all the SR map programming before hand and go back in and re-enter all the previous map info, right? or is there something else that they might have reprogrammed into it and would also be lost?

 

There might be other stuff, I think there's stuff they can program using the software, that you can't program using the just the commander.