rx3 street/strip build
#228
#229
#231
[QUOTE=gusfd3s;10738577]I bought this car back in 2006, i started doing a backhalf/4link conversion but the project was too big for me at that time since i had pretty weak fabrication experience,
Well, there seems to be a massive increase in your fab skills now. Keep up the great work.
Darryl
Well, there seems to be a massive increase in your fab skills now. Keep up the great work.
Darryl
#236
email
Hi there. I'm from Sydney australia. I am also building a rx3 coupe.
I was wondering if you would do a rx3 enthusiast a big help.
Would it be possible to get a copy of all your drawings. I don't mind paying a fee. I hope to hear from you soon.
my email is
Infinitus_enterprises@hotmail.com
Thank you
I was wondering if you would do a rx3 enthusiast a big help.
Would it be possible to get a copy of all your drawings. I don't mind paying a fee. I hope to hear from you soon.
my email is
Infinitus_enterprises@hotmail.com
Thank you
#242
There has been som changes to the project.. i had a 20b thick center iron and a crank so i thought id make a 20b engine out of 90% 13b parts.
Perfect!
Going full 12.7 stud kit. Alot of machining!
Rear iron finished with a new chamfer
Solid dowels
Modified center iron for direct oil feed+breather
REW rotors has been side clearanced and the assembly fully blanced.
Block ready for assembly
Adding another runner to the manifold
Perfect!
Going full 12.7 stud kit. Alot of machining!
Rear iron finished with a new chamfer
Solid dowels
Modified center iron for direct oil feed+breather
REW rotors has been side clearanced and the assembly fully blanced.
Block ready for assembly
Adding another runner to the manifold
#247