I successfully pulled the windshield on the duece to repair some corrosion issues. Now the dilemma is how to seal the glass when I reinstall it: Do I use the ribbon type of windshield caulk or the urathane in a can?

 

dont be a cheap ***. bring it to a professional auto glass shop

 

Already have it out Its not being cheep...Its saving $$$ for parts

 

lol. I missed that part. ok, then dont be cheap and have a professional auto glass shop install it for you. besides, if you have missing clips, they can use the caulking to keep the trims in place.

 

Here are some shots of the previously accomplished repairs performed by Previous Owners:

 

that is some fugly ****!

 

This reminds me I have to replace my windshield in my rx2 sedan.

Oh Banzai, I sent out my pitman arm to TED at Rare parts and he is in the slow process of rebuilding it. Thanks for the tip off.

 

It'll be better

 

Stripped the paint off the windshield area Now to prep and repair the holes

 

Give me about 24 hours and il be right by your side. I realy dont like this rust..

 

I found another problem area:

Pull the wiper access covers; you will see the horizontal surface is covered in a tar sheet. My sheet was cracked and under there was a LOT of corrosion! Now to figure out how to pull the wipers

 

That doesnt look so bad here. But i havent removed anything yet. guess i have to see tomorrow.