Modify RB Streetport exhaust for Rx-2
02-06-04 | 06:41 AM
#1
Thread Starter
Rotary Power !
iTrader: (1)
Joined: Mar 2002
Posts: 534
Likes: 0
From: Belgium, Europe
Modify RB Streetport exhaust for Rx-2
Has anyone done this ?
I want to use a 1st gen Rx-7 street port exhaust on an Rx-2. I was expecting the thing to be too long but it turns out it is about 10 inches to short !
The car has a 79 Rx-7 engine and transmission and stock driveshaft so my engine is more to the front than original.
I want to use a 1st gen Rx-7 street port exhaust on an Rx-2. I was expecting the thing to be too long but it turns out it is about 10 inches to short !
The car has a 79 Rx-7 engine and transmission and stock driveshaft so my engine is more to the front than original.
02-06-04 | 10:04 AM
#2
if youre trying to install the entire FB sp exhaust (headers, pipes & muffler), it may not work. You have to bring it to a muffler shop so they can install new pipes between the headers and muffler. also, run dual pipes into one muffler; thats in case you decide to run a ported motor in the future.
you can use different sizes:
2
2 1/8 - ideal set up.
2.5 - this will be too loud.
you can use different sizes:
2
2 1/8 - ideal set up.
2.5 - this will be too loud.
