rotarydreams89

I purchased my FC in July of 2007. When i drove it, it would overheat and sometimes not start. I later found out that the catalytic converter was clogged. After repairing it at a muffler shop it ran until January of 2008. In that time period i went throught two alternators too. The engine cranks but doesn't start. It has 129,000 miles on it. Before it stopped running it began overheating again. The temp read past the H on the meter. A mechanic told me that the engine has low compression. Is it time for a rebuild or is there anything else i can do just to keep it running?

IanS

iTrader: (4)

You should check the compression yourself just to make sure. There are threads that explain how to do this. Overheating a rotary is normally a very bad thing so it is likely that it needs a rebuild but check compression first to make sure.

JoeyMazda

I work with my own car am a rotary mechanic and I've seen this problem many times.Most likely you might need to overhaul the engine and need new housings because that's what might be causing your overheating problems. Buy a rebuilding kit and new housings.Rebuilding the engine alone won't help.

rotarydreams89

You have been very helpful. I will see what i can do. I did have plans on swapping a T2 motor in anyway. I wanted to swap the auto trans for a 5 speed too.

rotarydreams89

Is there a way to convert my NA 13B block into a 13BTblock? What will i need to achieve this build? Roughly how much will it cost?