problems with the coil packs
#29
It's located on the passenger side of the engine between the Pressure/Boost Sensor and the engine. The harness which plugs into the sensor mentioned is where the check connector will be found. You'll have to fish for it as it is usually located under the Emission harness in a Black rubber boot. The plug is Yellow and has but two wires, one Brown and one Black. Jumpering is where you use a single piece of bare wire stripped at both ends and you take the jumper wire formed in a U shaped design and you bridge both of the wires in the check connector. Easiest to jumper the two wires from the back of the connector.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 08:16 PM
SakeBomb Garage
SakeBomb Garage
0
09-04-15 06:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 06:19 PM