new and have problems i believe.
#26
Moderator
iTrader: (1)
its idling at 900 but i made it that high cause if i turn on my lights and depress the brakes or turn my fan blower on it will lower to about the fat line close to the bottom of the tach. which is 500 rpm i believe and it makes my voltage drop low like just above 12volts
#29
Full Member
Thread Starter
Join Date: Nov 2010
Location: columbus ga
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
can anyone post a pic of what order the color wires go into the heat/
AC controller. i need heat and there are no wires to splice on the controller circuit. and i need heat. its been 40 and below here and not too fun to drive. i looked on the FSM but it doesnt say the wire color order they go in.
AC controller. i need heat and there are no wires to splice on the controller circuit. and i need heat. its been 40 and below here and not too fun to drive. i looked on the FSM but it doesnt say the wire color order they go in.
#30
Full Member
Thread Starter
Join Date: Nov 2010
Location: columbus ga
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
oh yeah and also the BAC wasnt working im gonna take it off soon and try to clean it out and see if i can fix it. looked how much they would go for and it was in the $500-600 range. and i cant afford that right now XD
#31
Full Member
Thread Starter
Join Date: Nov 2010
Location: columbus ga
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
can anyone point me to a picture of the order the heat/AC controller wires go into the logicon computer chip? or tell me what order they are in. i cant use my heat because there are no wires coming out of the chip to splice to the harness and i dont have one to compare to. its starting to get 25 and below down here and i need heat bad
#32
Full Member
Thread Starter
Join Date: Nov 2010
Location: columbus ga
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
i put i new BAC valve on it and and it still acts the same......... how would it act if the harness was bad cause it think the alt. was grounded on the strut before and i think that could cause the wiring harness to go bad. (my friends car did that once)
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM