clutch/ flywheel help
12-13-08, 09:46 AM
#1
DETROiT RiOT RACiNG
Thread Starter
Join Date: Aug 2008
Location: 313 michigan
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
clutch/ flywheel help
i'm reusing my clutch and pressure plate that i got with the motor (s4 n/a) but i did not mark thier relationship to oneanother with a marker or paint. is this a huge problem? then i threw away my clutch bolts because i was planning on getting new ones. but now i dont know what size or anything to get. is there a certain size? length? thanks for the help
12-13-08, 10:12 AM
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 110 Likes
on
93 Posts
The orientation does not matter as the assembly is balanced. HOWEVER, sometimes there are balance washers on a specific bolt which need to be reinstalled where they were taken out. Since you've thrown out all the hardware (NEVER DO THIS UNLESS YOU KNOW WHAT YOU NEED TO BUY) that's kind of not possible anymore. I'm fairly sure the bolts are M8 x 1.0, but check the bolt thread/pitch thread in the 2nd gen Archives to be sure.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM