Naturally Aspirated Performance Forum Discussion of naturally-aspirated rotary performance. No Power Adders, only pure rotary power! From the "12A" to the "RENESIS" and beyond.

how to tell engine's strength (fairly new rebuild)

Thread Tools
 
Search this Thread
 
Old 06-13-10 | 12:19 PM
  #1  
johnturbo's Avatar
Thread Starter
Full Member

 
Joined: Jul 2009
Posts: 116
Likes: 0
From: new jersey
how to tell engine's strength (fairly new rebuild)

i have my rx7 fc and when i gave the car gass in gear the car pulled out, but not with the same power as my other 7's... so i changed the mass air flow sensor to see if it would help, but it didnt.. so im not sure if the compression is good or not any ideas what could be the cause to my lack of power? any suggestions for a good ignition setup also?
Old 06-13-10 | 01:45 PM
  #2  
j9fd3s's Avatar
Moderator
iTrader: (3)
 
Joined: Mar 2001
Posts: 31,203
Likes: 2,826
From: https://www2.mazda.com/en/100th/
a compression test might be a good start. if that's good then you can move on to things like the TPS, timing, fuel filters, checking the exhaust backpressure etc etc




All times are GMT -5. The time now is 01:28 AM.