Like Tyler said, it's the Sonic by Chapel Hills mall, and we meet at 630.

Well we're just worried about the OMP lines cause he has it kinda rigged again...and we all know what happened LAST time hahaha.

 

Thats crazy he would even rig it up like that to begin with, you think he would've learned his lesson.... I know I did and it wasn't even my car!!!!

 

Well we'll see, his lines should be here tomorrow cause I got my thermostat and Corey's gasket today and I ordered his lines the very next day.

 

We start the swap tomorrow. I am going to be a bit jealous with all these single turbo Rx7's running around. Damn it.....

 

only about a month and a week til i move! AND my turbo is consuming enough oil to essentially run the car (if it was a diesel)

 

I'm working on getting this Friday's meet a larger one. There will be a group from Denver coming down. I want to get as many cars as we can this week.

 

You guys have been real quiet the past few days. Whats up?

 

We started Eric's swap on Saturday. He is close. It sucks that this week is going to be big since I am leaving town for the weekend. I guess I will have to wait until the 20th to meet the Denver folks.

 

Yeah I'm pretty much finished except for the welding parts. I still need to check for leaks and make sure my vacuum lines are correct. I SHOULD be able to drive it to the meet if everything plays out correctly tomorrow. Or today rather haha.

 

Hope it all works out. If you need any help getting it together my number is posted on CMZC. I get off work at 11:30am.

 

Well I just primed the fuel to check for leaks and my primary injectors are leaking at the rail. So I will NOT be at the meet tonight.

I still need a 90 degree IC coupling, a reducer that goes from from 2.5 to 2.75 inches, I ordered it from Underpressure. AND I need a belt for my alternator/WP, I ordered that from NAPA.

It just wasn't meant to be tonight, and possibly not for quite a while still haha.