Fasteners/Bolt/Screw Store Chicagoland AreaH
#1
Fasteners/Bolt/Screw Store Chicagoland AreaH
I am looking for a Fasteners, Bolts, or Screws store. Something to find those specialty bolts and screws you are dumb enough to drop on the ground and lose.
I usually go to mcmaster carr but I don't need 100 of these...just one.
Thanks.
I usually go to mcmaster carr but I don't need 100 of these...just one.
Thanks.
#4
I checked, they had half of what I need.
I need a M5 x .5 (M5 fine thread) as a threaded rod or a set screw. Basically something to make a longer idle adjust screw.
There is no Mid-States Bolt and Screw by your school fidelity, but if you know of that place I am looking for something like that.
I need a M5 x .5 (M5 fine thread) as a threaded rod or a set screw. Basically something to make a longer idle adjust screw.
There is no Mid-States Bolt and Screw by your school fidelity, but if you know of that place I am looking for something like that.
#5
I checked, they had half of what I need.
I need a M5 x .5 (M5 fine thread) as a threaded rod or a set screw. Basically something to make a longer idle adjust screw.
There is no Mid-States Bolt and Screw by your school fidelity, but if you know of that place I am looking for something like that.
I need a M5 x .5 (M5 fine thread) as a threaded rod or a set screw. Basically something to make a longer idle adjust screw.
There is no Mid-States Bolt and Screw by your school fidelity, but if you know of that place I am looking for something like that.
Trending Topics
#10
I won't let go
![](https://www.rx7club.com/images/ranks/veteran_marine_corp.png)
![](/images/misc/20_year_icon.png)
I found a tap in that size for ya.
Why not tap it to a more common size like .8 or 1.0 and then you'll be able to source what you need.
Just a thought.
![Big Grin](https://www.rx7club.com/images/smilies/biggrin.gif)
Why not tap it to a more common size like .8 or 1.0 and then you'll be able to source what you need.
Just a thought.
#11
I have thought about that, but I am set on buying a tap n die set all at once to save some money. I am not quite ready to do that.
I can get threaded rod from mcmaster carr, but its $35 or so. Using it as my last option. The nuts I got from ace are also thinner so I may be able to sneak enough room and not need a longer set screw.
I can get threaded rod from mcmaster carr, but its $35 or so. Using it as my last option. The nuts I got from ace are also thinner so I may be able to sneak enough room and not need a longer set screw.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM