Megasquirt My Contribuation to the MS2 Guide
Trending Topics
03-01-09, 05:52 PM
#10
MegaSquirt Mod
EAE isn't really a "throttle pump" anyway. It's a wall-wetting-based accel enrichment algorithm.
Throttle pump is more or less what the original accel enrichment did.
In any case, EAE needs some work before I'd use it with staged injection. It might do strange things there. When the secondaries come on. I really need to make independent settings for primaries vs secondaries since the wall-wetting characteristics are going to be a lot different between the two.
Also, for a stock CAS stab, the tooth #1 angle should be 5 degrees, but as long as the CAS is adjusted for the angle you use, it's not a big deal.
Ken
Throttle pump is more or less what the original accel enrichment did.
In any case, EAE needs some work before I'd use it with staged injection. It might do strange things there. When the secondaries come on. I really need to make independent settings for primaries vs secondaries since the wall-wetting characteristics are going to be a lot different between the two.
Also, for a stock CAS stab, the tooth #1 angle should be 5 degrees, but as long as the CAS is adjusted for the angle you use, it's not a big deal.
Ken
Last edited by muythaibxr; 03-01-09 at 05:55 PM.
03-01-09, 09:37 PM
#11
EAE isn't really a "throttle pump" anyway. It's a wall-wetting-based accel enrichment algorithm.
Throttle pump is more or less what the original accel enrichment did.
In any case, EAE needs some work before I'd use it with staged injection. It might do strange things there. When the secondaries come on. I really need to make independent settings for primaries vs secondaries since the wall-wetting characteristics are going to be a lot different between the two.
Also, for a stock CAS stab, the tooth #1 angle should be 5 degrees, but as long as the CAS is adjusted for the angle you use, it's not a big deal.
Ken
Throttle pump is more or less what the original accel enrichment did.
In any case, EAE needs some work before I'd use it with staged injection. It might do strange things there. When the secondaries come on. I really need to make independent settings for primaries vs secondaries since the wall-wetting characteristics are going to be a lot different between the two.
Also, for a stock CAS stab, the tooth #1 angle should be 5 degrees, but as long as the CAS is adjusted for the angle you use, it's not a big deal.
Ken
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
Auroraw0lf
New Member RX-7 Technical
5
09-15-15 04:55 PM
