puting in head unit
#1
****ty Tune= Low #'s
Thread Starter
puting in head unit
i just got a new jvc head unit and got everyhting i needed from crutchfeiid and when i took out the old school tape player i looked at the wiring and holy **** somebody did a bad job.....he cut all the harnesses off which the crutchfeild harness was useless and then everything was jsut like taped with scotch tape that had melted and ****......so now i have to pay $60 to go get a auido shop to rewire my car because it is so messed up.....i have installed like 10 head units and my brother works at a shop and like they guy some how got it to have 2 wries work both front speakers.....and then the other two work 1 left front and 1 back right........so when i did all that testing i wa slike **** and the other harness with the jvc wont fit so this sucks did anyone else have this problem or am i just always gettin messed over??
#2
Recovering Milkaholic
iTrader: (7)
If you have the wires coming out of the head unit just wire it to the car direct.
Its
Black=ground
red=12v
yellow=12v momory
light blue ATT
blue with white stripe=power antenna
then the
rest are speaker wires.
2 Grey, one with stripe is positive
2 White, one with stripe is positive
2 Green, one with stripe is positive
2 Purple, one with stripe is positive
You can find which is which buy touching the wires to a regualr double A battery, one wire on one end the other to the oposite end. The speaker will make static so you can identify it.
Its
Black=ground
red=12v
yellow=12v momory
light blue ATT
blue with white stripe=power antenna
then the
rest are speaker wires.
2 Grey, one with stripe is positive
2 White, one with stripe is positive
2 Green, one with stripe is positive
2 Purple, one with stripe is positive
You can find which is which buy touching the wires to a regualr double A battery, one wire on one end the other to the oposite end. The speaker will make static so you can identify it.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM