I want a system!!!!(not a used one )
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2002
Location: Tuscaloosa, AL
Posts: 1,430
Likes: 0
Received 0 Likes
on
0 Posts
I want a system!!!!(not a used one )
ok, Does anybody have pics of there system in a fd??? I think mt next fd is going to have a system. How would 2 w7 10'' hold up in a fd??? do any of you guy have **** rattling and stuff in the back?? Does dyno matt cure all rattle???
#2
Driven a turbo FB lately?
iTrader: (1)
Why does everyone seem to think dynamat is a cure all for everything? Dynamat sheet is for the sole purpose of adding weight to something such as a long flat roof, or a trunk lid. There are other ways of killing rattles, silicone, foam etc .. Must cheaper at that...
Best thing to do is get a test disc with different bass tones, each tone plays about 30 seconds and gives you time to see what is rattling at what bass note.
W7's are very expensive, and the other drawback to them is they are VERY deep (dimensional) subs... But ayt any rate most anything Jl made/makes is good.
Best thing to do is get a test disc with different bass tones, each tone plays about 30 seconds and gives you time to see what is rattling at what bass note.
W7's are very expensive, and the other drawback to them is they are VERY deep (dimensional) subs... But ayt any rate most anything Jl made/makes is good.
#3
Rotary Enthusiast
Thread Starter
Join Date: Mar 2002
Location: Tuscaloosa, AL
Posts: 1,430
Likes: 0
Received 0 Likes
on
0 Posts
thanks mike. I thought about just getting one but I dont anything to cover the sub up. I think 2 would look alot better than one. I can get very good deals things like this. I just want see what you guy box and stuff look like. What does it cost to get a box made that will fit in the trunk of a fd or hatch.
#4
Full Member
iTrader: (3)
Join Date: Sep 2002
Location: c-bus, ohio
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
hey 93redfd i would go with one jl 10w7 i have one not in my fd but if you get enough wattage going to it you will be very pleased with the oucome. plus in an fd you would be pushing it to get proper airspace for two 10w7's. so once again i recondmend one.
#5
Rotary Enthusiast
Thread Starter
Join Date: Mar 2002
Location: Tuscaloosa, AL
Posts: 1,430
Likes: 0
Received 0 Likes
on
0 Posts
somebody told me this about a w7 and I was about to argue but I dont know much about audio. This person said that a w7 would suck dents in trunk hatch and the rear 1/4's.. Is this true, are they that powerful??? THe only way I think that it could suck dents is unless the car was air tight shut..
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM