Anyone ever use GTP V*FRP products?
07-08-10 | 03:23 PM
#2
Chaser on GTP
I had the same question so I contacted Chaser on the subject, this was their reply:
Have you gotten any first-hand feed back or experience to report?
The GTP frp product are nice quality. Being a aftermarket composite
product there may be some minor fitment that need to be addressed like
trimming , sanding or cutting. If you don't have experience with
aftermarket composite it parts I would recommend finding a custom
autobody shop that is good in your aera.
product there may be some minor fitment that need to be addressed like
trimming , sanding or cutting. If you don't have experience with
aftermarket composite it parts I would recommend finding a custom
autobody shop that is good in your aera.
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM
