Haltech Walbro and GrandNational BOSCH 1600cc injectors
02-04-02 | 09:54 PM
#1
Thread Starter
Rotary Freak
Joined: Mar 2001
Posts: 1,611
Likes: 0
From: LA.,California USA
Walbro and GrandNational BOSCH 1600cc injectors
Can i use the Bosch 1600cc injetors that they use for the grand Nationals???..its rated for 2.2 to 2.4 ohms..
And should i buy the Walbro 307 or the 340??..
I was told that the 307 is good for up to 600HP. The 340 in the other hand is good if you see above 70 psi of fuel at WOT.
THis is for an 87TII with Haltech e6k and full t04b upgrade!!!..
Thanx in advance!
And should i buy the Walbro 307 or the 340??..
I was told that the 307 is good for up to 600HP. The 340 in the other hand is good if you see above 70 psi of fuel at WOT.
THis is for an 87TII with Haltech e6k and full t04b upgrade!!!..
Thanx in advance!
02-08-02 | 04:03 PM
#2
Haltech E6K
Joined: Feb 2001
Posts: 420
Likes: 0
From: Northern California (USA)
As stated many times before, the E6K uses seperate injector drivers which allows you to mix and match different injector impedences.
As far as the fuel pump goes I am not help. Part numbers do not mean much to me.
As far as the fuel pump goes I am not help. Part numbers do not mean much to me.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
