Rotary Tech support
#1
Newbie
Thread Starter
Join Date: Jun 2004
Location: Va.
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Rotary Tech support
Dead RX7
I have a 1991 RX 7 and I also have a
sledgehamer that I may have to use soon.
My dam car won't run !!!
It only sat for a few days while I did a brake job and now it won't start! I have fuel and Spark and it cranks
but won't fire up.
A day or so before this it started to act up a little and die out. I'm not sure if it was a ignition or fuel related problem.
I've only had this car a short time and don't know anything about Rotary. So if anyone has any suggestions it would help allot.
I have a 1991 RX 7 and I also have a
sledgehamer that I may have to use soon.
My dam car won't run !!!
It only sat for a few days while I did a brake job and now it won't start! I have fuel and Spark and it cranks
but won't fire up.
A day or so before this it started to act up a little and die out. I'm not sure if it was a ignition or fuel related problem.
I've only had this car a short time and don't know anything about Rotary. So if anyone has any suggestions it would help allot.
#2
Junior Member
Join Date: Jun 2004
Location: winter springs, fl
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
i dont have a ton of experience with rotaries but i do know that some of them have a problem with flooding. im not sure if one that new does it, but what usually causes it is you start it and move the car then shut it off, not allowing it to run very long. its not a big deal, you can pull the fuse for the fuel pump and crank it over for about 10 seconds. do this a couple of times, then put the fuse back in and see if it starts then. good luck
#3
try this ... Gen II Flooding Resolution
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM