Prepping engine for sitting engine?
09-10-10 | 08:38 PM
#1
Prepping engine for sitting engine?
Looking for the best and safest way to prep an engine that has sat for 2 years?
I've heard of the ATF trick, but not sure if that is the best way to do it.
I've heard of the ATF trick, but not sure if that is the best way to do it.
09-11-10 | 04:54 PM
#2
pour about 2 ounces of 2 stroke oil into each leading plug hole and reinsert the plugs and crank the engine over by hand for about 5 revolutions.
this is about all you can do for a rotary engine that has been sitting, after that just cross your fingers that the coolant seals can handle the inactivity and corrosion.
this is about all you can do for a rotary engine that has been sitting, after that just cross your fingers that the coolant seals can handle the inactivity and corrosion.
Thread
Thread Starter
Forum
Replies
Last Post
sandy_RE
Interior / Exterior / Audio
11
08-23-15 07:22 AM
