Port Ate my Cutting Tool >_>
#28
400WHP or bust
iTrader: (7)
Join Date: Oct 2003
Location: Walkerton, Ontario Canada
Posts: 4,048
Likes: 0
Received 0 Likes
on
0 Posts
The deeper you go, the less hard it is, I'm going to call BS. you might have a surface hardness of Rockwell 40c in the surface but that will become more soft the deeper you go.
#29
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,791
Likes: 0
Received 113 Likes
on
95 Posts
Having not seen the Mazdatrix video, I'm now very curious about the hand lapping. Basically smear valve grinding compound on two plates and then lap them against one another for an hour or so?
#32
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,791
Likes: 0
Received 113 Likes
on
95 Posts
Huh, I'll have to give that a try next time I build an engine. Too bad I have already blasted and painted the irons I'll be using for the Cosmo...
I've also heard of people using thick plate glass and fine grit sand paper to resurface irons at home.
I've also heard of people using thick plate glass and fine grit sand paper to resurface irons at home.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM