Calgary ~ Spring Mini-meet ~ Sat. April 22nd
#51
Rotary Freak
Join Date: Mar 2003
Location: Calgary, Alberta, Canada
Posts: 1,711
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 84stock
I hope nobody misses out on the header and exhaust. Brett, mannnnn you should've scored them for yours! Makes a big difference.
#53
My other car is a TVR
Join Date: Jun 2005
Location: Calgary
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dansuxx
ya i stole the tanny out of the car. the lsd rear end has a hole punctured through the back so it's nfg. header and exhaust is still there for the taking
chedda_j I read in another post was looking for a 12a header.... still looking dude?
[edit] Front/Back rotors are still there and are machinable I think....smooth but rusty.... also has front struts.
[edit again] BTW, the header is for sale. I bought mine for over $200 USD from RB.... I figure $50 for the part and labour to cut off rusty flange studs is worth that.
Last edited by Ctrl; 04-27-06 at 12:18 AM.
#54
My other car is a TVR
Join Date: Jun 2005
Location: Calgary
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 84stock
No No No, it's not that lound. It's only that loud when you throw a ricer fart can on the back to go with it. On my stock 12a it was a pleasant change, it only got loud when i threw a magnaflow on it to with the header.
I often find a lot of cars that could kick my ***, give up the race for the sole reason they can hear my 1st gear outlast theirs by a good couple seconds and figure I have the juice to do it in second and third. (I don't) It's the equivalent to "fake them out"...lol
#57
Full Member
Join Date: May 2005
Location: Alberta, Canada
Posts: 180
Likes: 0
Received 0 Likes
on
0 Posts
I missed a mini-meet and a Peter's shake all on the same night. I've been so busy that I haven't been reading the forum. I found out about it when I ran into Aviator and Ctrl the next day while I was pulling the seats out of that car at pick-n-pull.
Oh well, next time.
PS: Brett, feel free to message me about that door whenever you're ready.
Oh well, next time.
PS: Brett, feel free to message me about that door whenever you're ready.
#58
Rotary Freak
Join Date: Mar 2003
Location: Calgary, Alberta, Canada
Posts: 1,711
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Doctor.Jekyll
I missed a mini-meet and a Peter's shake all on the same night. I've been so busy that I haven't been reading the forum. I found out about it when I ran into Aviator and Ctrl the next day while I was pulling the seats out of that car at pick-n-pull.
Oh well, next time.
PS: Brett, feel free to message me about that door whenever you're ready.
Oh well, next time.
PS: Brett, feel free to message me about that door whenever you're ready.
Thread
Thread Starter
Forum
Replies
Last Post