1/2" NPT tap
#1
Rotary Enthusiast
![](https://www.rx7club.com/images/misc/15_year_icon.png)
Thread Starter
iTrader: (1)
Join Date: Feb 2004
Location: Waterloo & Mississauga, Ontario, Canada
Posts: 838
Likes: 0
Received 1 Like
on
1 Post
1/2" NPT tap
Hey guys,
I'm having a hard time finding a 1/2" NPT tap- I was wondering if anyone knows of any good tool shops in the GTA or Waterloo, that would carry one of these.
Thanks!
I'm having a hard time finding a 1/2" NPT tap- I was wondering if anyone knows of any good tool shops in the GTA or Waterloo, that would carry one of these.
Thanks!
#3
Rotary Enthusiast
![](/images/misc/20_year_icon.png)
Spae-Naur will have it, but they are quite proud of their inventory. I would think Princess and TSC would have it as well, at a better price. What are you tapping that big, turbo drain fitting??
#5
Rotary Enthusiast
![](https://www.rx7club.com/images/misc/15_year_icon.png)
Thread Starter
iTrader: (1)
Join Date: Feb 2004
Location: Waterloo & Mississauga, Ontario, Canada
Posts: 838
Likes: 0
Received 1 Like
on
1 Post
you got it renns, turbo drain
I didn't do the first one right, and now its leaking - so time to do it properly!
I'll check Spaenaur tomorrow, thanks guys!
I didn't do the first one right, and now its leaking - so time to do it properly!
I'll check Spaenaur tomorrow, thanks guys!
Last edited by darkfrost; 06-27-07 at 09:13 PM.
Trending Topics
#10
Rotary Enthusiast
![](/images/misc/20_year_icon.png)
Do you have a drill large enough to pre-drill before tapping? If not, add that to the list as well. If the front cover is off you may find it easier and cheaper to just take it to someone to get the job done. That way it's done right, and you don't have high $$ one-time use tools kicking around.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM