The Story of My FD and my single turbo build (from Argentina) **Heavy post**
#52
Can probably find it cheaper, but here is what I'm talking about:
http://www.racingbeat.com/RX7-1993-1...ges/16187.html
Just buy it and have it welded to your header.
http://www.racingbeat.com/RX7-1993-1...ges/16187.html
Just buy it and have it welded to your header.
#53
Full Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Argentina
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Can probably find it cheaper, but here is what I'm talking about:
http://www.racingbeat.com/RX7-1993-1...ges/16187.html
Just buy it and have it welded to your header.
http://www.racingbeat.com/RX7-1993-1...ges/16187.html
Just buy it and have it welded to your header.
Mmmm interesting!!!! thanks man!!! maybe i can fabricate something like that here, cause if i buy it, i have to wait 3 weeks...
#57
Senior Member
iTrader: (13)
One solution might be to cut a very small wedge (maybe the width of a cut off wheel) out of the runners immediately under the turbo flange on the side furthest from the engine, hammer the flange back down to close the gap, test fit it, cut more if necessary, then weld it back up. This would tilt the turbo away from the engine giving you the needed space.
#58
Full Member
Thread Starter
iTrader: (1)
Join Date: Jul 2010
Location: Argentina
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
ok, here we go again...
i have the blank flange, thanks to mazdatrix....
then i make a new wiring for my injectors with the resistors, i don't know if that is the best place for them, but they are secured to the solenoid rack very firmly
i started to connect a lot of clips and before doing that i put a lot of this "contact" cleaner, called "contactmatic", i don't want "connection problems" and i also changed a few old wires
and then i take care of my ignition
it's not a lot, but at least is something, i also show you a pic of my new toy, she is the one who took me all the time i needed to build my car... but it's one of the funniest thing i ever had
see yaa!
sorry about my english
i have the blank flange, thanks to mazdatrix....
then i make a new wiring for my injectors with the resistors, i don't know if that is the best place for them, but they are secured to the solenoid rack very firmly
i started to connect a lot of clips and before doing that i put a lot of this "contact" cleaner, called "contactmatic", i don't want "connection problems" and i also changed a few old wires
and then i take care of my ignition
it's not a lot, but at least is something, i also show you a pic of my new toy, she is the one who took me all the time i needed to build my car... but it's one of the funniest thing i ever had
see yaa!
sorry about my english
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM