Originally Posted by GoodfellaFD3S
(Post 9975834)
(I havent read your entire thread, so forgive me if I'm asking questions you've already answered)
You didn't leave the fuel diffusers in, did you? Also, if running a Power FC I'd recommend against the resistors in the injector wiring and instead installing an FJO injector driver. Also, make sure you heat sleeve the ABS line that runs near the DP. You can unplug it in the back rear corner of the engine bay (under the ABS unit) and slide some nice DEI fire sleeve over it. It's a great idea to heat sleeve as much as you can on that side of the bay, actually. Looking good :icon_tup: I've already got a FJO Injector Driver unit on the way. I'm also planning on doing the heat sleeving, but I'm waiting to have EVERY line installed on the car so I can do it all at once. I'm also going to use heat shield on the passenger frame rail/strut tower.
Originally Posted by KKMpunkrock2011
(Post 9975856)
that sard rail is cool, how does it all work? feed line to the secondary rail and lines from the center an fittings to the primary rail and back then to the FPR and return?
|
nice build, its giving me flashbacks and brings back so much memories of what i went through with mine a while back, keep up the good work
|
Hi,
I have the same kit, but I am struggling to figure out the Japanese Instructions. Do you have a pic of the injector fiited to the rail ? I have fitted the small blue collar but this is crushing the rubber grommet on the injector or do I remove this. Also where did you source the 1600cc Injectors, the largest Injectors I could find was 1000cc without modifying the rail. Regards, Paul |
The blue spacers takes place of the rubber cushion, remove it. I ordered RC injectors and told them I needed denso style injectors, which makes the top of the injectors slide right in, also if you go this route you don't use the blue spacers on the RC injectors because the spacers section is built onto the injector.
Originally Posted by Scouse
(Post 9984776)
Hi,
I have the same kit, but I am struggling to figure out the Japanese Instructions. Do you have a pic of the injector fiited to the rail ? I have fitted the small blue collar but this is crushing the rubber grommet on the injector or do I remove this. Also where did you source the 1600cc Injectors, the largest Injectors I could find was 1000cc without modifying the rail. Regards, Paul |
Hi,
Many thanks for the reply. Have you got a link to where you got the injectors. Many thanks Paul |
All times are GMT -5. The time now is 05:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands