2 things

1. has anyone mounted their meth tanks in the boxes on a FC? If i take it to a drag strip with them in there will it pass tech inspection?

2. if you want to buy those plastic meth/water tanks all the ai sites sell them for 30$ buy it from http://www.usplastic.com/catalog/pro...uct%5Fid=14120
its much cheaper... like $10/per.

 

I think if you run 100% meth in the passenger compartment you may have trouble.
Wow! They have a 2.5 gal tank for $20.84
Thanks,
Barry


http://www.usplastic.com/catalog/var...iant%5Fid=8665

 

if you are going to run 100% methanol you need a fuel cell not a plastic jug w a screw-on top. that is fine for water injection and a 50-50 mix which won't burn... not alcohol.

consider it exactly the same as gasoline.

here's what i run along w all stainless steel braided lines and brass fittings..

http://www.jegs.com/webapp/wcs/store...0002_758786_-1

$145 for a 4 gallon cell. more expensive yes, but...

please see my thread regarding compnent location for further help.

https://www.rx7club.com/auxiliary-injection-173/optimized-ai-alcohol-system-component-location-fd-586925/

good luck and i know you will get hooked on the alcohol. i did.

howard coleman

 

thanks howard. as always great advice. if i have one of those cells mounted properly, will i have to do anything to mount it int the passenger compartment to pass tech inspection for soem weekend drag racing or road course racing?

 

those fuel cells are made of polyethylene...so are these tanks made by flambeau. Just have to have a vent tube to vent vapors to outside of the car and it will be good

this is what i did...on my meth injection setup:

 

Thats a damn nice looking setup. Where did you purchase the bottles from? Directly from the company or do they have a distributor?

Chris

 

http://fluids.flambeau.com/multipurp...5.0_quart.html

they have a wide selections of sizes and shape and ~$20ea

note: get the tallest and narrowest bottle possible - minimise gas bubbles created from sloshing going onto the pump intake and also lessens the triggering of failsafe float switch from liquid movement.

 

Does anyone make a round donut type tank that would fit in the spare tire well? I found a cell for a full size spare but it is to large. (#171115, 8 gal well tank ATL 22”dia x 6” ).
Barry

 

Hey, that looks pretty good SlowCar2.

8gal fuel cell, Barry? Don't need anywhere near that large a reservoir. I've used my 1gal cell and it seems to last a good amount of time!!

B

 

we all may need different sized cells... i really am happy w my 4 gallon size. particulars are in my thread re my installation. i run 2 M10 nozzles and you wouldn't believe how much they can put out.






howard coleman

 

I'm still on the fence in terms of cell-size totality, but 1gal seems to be good so far. But, then again, I haven't cranked my new 2xM10 nozzle setup yet. That was with the use of the single M15 at low-mid 400rwhp.

B