Cooling mist - Clog detector valve?
04-27-08 | 02:28 AM
#1
Thread Starter
Turbo widebody FB
iTrader: (1)
Joined: May 2004
Posts: 3,733
Likes: 3
From: Alberta Canada
Cooling mist - Clog detector valve?
Hey guys,
Just bought my cooling mist kit a little while ago and have it mostly hooked up now. Just have one question. This valve setup was supplied with the kit just want to make sure I hook it up properly. Is this a clog detector? The instructions don't show anything pictured like this. It has connections for normally open, normally closed and a common. But doesn't describe how it needs to be hooked up.
Any help is appreciated, thank you!
Just bought my cooling mist kit a little while ago and have it mostly hooked up now. Just have one question. This valve setup was supplied with the kit just want to make sure I hook it up properly. Is this a clog detector? The instructions don't show anything pictured like this. It has connections for normally open, normally closed and a common. But doesn't describe how it needs to be hooked up.
Any help is appreciated, thank you!
04-27-08 | 11:05 AM
#2
Thread Starter
Turbo widebody FB
iTrader: (1)
Joined: May 2004
Posts: 3,733
Likes: 3
From: Alberta Canada
Read a bit closer in my supplied instructions and I found the information I needed. Looks like I just hook up a LED with 12V to one side and hook the other side to the NO port, and ground the COM port.
04-27-08 | 01:47 PM
#3
Banned. I got OWNED!!!
Joined: Jan 2005
Posts: 296
Likes: 0
From: Atlanta
Correct. It will light up when the system injects. Once the system stops injecting the light will go out. If its ever litup when you are not in boost, you either have a clog OR the system is injecting.
CM
CM
04-28-08 | 08:39 PM
#5
Joined: Dec 2001
Posts: 7,093
Likes: 122
From: Twin Cities, MN
Make sure it has a good ground or it will act funny.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 04:25 PM
