white powder
06-04-05, 12:22 AM
#1
Full Member
Thread Starter
Join Date: Jun 2004
Location: po-town New York
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
white powder
no not that kind, heh, i pulled off my pre-cat and yeah inside each pipe end is white powder which im told means that im running really lean?? (as i go "oh $hit") any words on how to remedy this ?
also my idle is resting at arnd 2500 rpm's with the climate control fan all the way on....with it off it bounces down to abt 1000 rpm's and back up to 2500 at abt half second intervals, checked all the vacuum lines,one check valve was busted but even after replacing it and some lines (2) it was still the same. i was hoping it was just maybe a vacuum leak? also the re-circ. valve is dumping boost and occasionally i get the smell of gasoline pretty strong
(correlation of gas smell and engine running lean = leak??)
on a lighter note everyone like my new vanity plate (in the avatar)? hehe well not yet anyway maybe later when im in less hot water with the po-po's =D
also my idle is resting at arnd 2500 rpm's with the climate control fan all the way on....with it off it bounces down to abt 1000 rpm's and back up to 2500 at abt half second intervals, checked all the vacuum lines,one check valve was busted but even after replacing it and some lines (2) it was still the same. i was hoping it was just maybe a vacuum leak? also the re-circ. valve is dumping boost and occasionally i get the smell of gasoline pretty strong
(correlation of gas smell and engine running lean = leak??)
on a lighter note everyone like my new vanity plate (in the avatar)? hehe well not yet anyway maybe later when im in less hot water with the po-po's =D
Thread
Thread Starter
Forum
Replies
Last Post
frosty1993
General Rotary Tech Support
3
09-30-15 01:27 PM
